Please Log In

Forgot your password?

Hop on board...

Are you a new Customer? Click here to register.

Loading Zoom, please wait

Square Plate Simple Curve Mould 8299 (15.4cm x 15.2cm x 1.7cm)

Price £17.89 Inc VAT (£14.91 ex VAT)

4.5 out of 5 stars (4 Customer Reviews)
 Go Back to Square Moulds 

All prices include VAT.

Stock Status: More than 10 in stock
We Also Recommend for Square Plate Simple Curve Mould 8299 (15.4cm x 15.2cm x 1.7cm):
Product Information
Square Plate Mould 8299

Create an elegant and practical dish with this mould. Produces a square plate with a simple, pleasing curve.

Inner Dimensions: Length: 15.4 cm, Width: 15.2 cm, Height: 1.7 cm 
Outer Dimensions: Length: 15.8 cm, Width: 15.9 cm, Height: 2.4 cm 
Base Dimensions: Length: 8.7 cm, Width: 8.5 cm

Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. Mould manufacturers allow a tolerance of up to 2cm. We strongly recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.

Will this mould fit in my kiln?

You might also like the Square Platter mould 8038.


Firing Schedule:

Please Read: This firing recommendation has been calculated using Bullseye Glass with a thickness of 6 mm in a Paragon GL24 kiln, and is courtesy of Bullseye Glass Co. 

Segment Rate (C/hr) Temp. Hold
1 167C 663C 1:30
2 999 482C 1:00
3 56C 371C :00


  • Small kilns may require the process temperature reducing. In the Hobbyfuser and HotStart Pro, reduce the top temperature from 663C to 650C. In the Firebox 14, reduce the top temperature from 663C to 640C. All kilns vary, as does glass viscosity. Testing is necessary.

  • Remove the shelf when slumping in small kilns.

  • Side firing kilns may require more time in the first ramp than top firing kilns.

  • Bubbles in slumping are caused by firing too high or holding too long at process temperature.

  • Cracked moulds or cracked glass is caused by firing too fast in the first ramp or cooling too fast.

  • Devitrification on the outside of a slumped piece is caused by firing too high or holding too long at process temperature.

All our moulds are designed for multiple use and with care should last for many firings.

Product Reviews
4.5 out of 5 stars
3 out of 5 stars Monday 23 April, 2018 By Ally Caldecote - See all my reviews
Personally I quite like this mould, but more than a couple of people have described it as looking a little like an ashtray, which is not quite the look I was going for!
5 out of 5 stars Tuesday 09 January, 2018 By Jessica Dewey - See all my reviews
I use this mould quite a lot and have had great results!
5 out of 5 stars Tuesday 29 August, 2017 By Josina Bowering - See all my reviews
A nice shape mould either used in full or just using the centre with a 10x10 to get a shallow dish.
5 out of 5 stars Saturday 28 January, 2012 By patricia mallen - See all my reviews
Nice neat mould Good versitile shape
very happy with results

Write a review

Registered office: 5 Havyat Park, Wrington, Bristol, BS40 5PA, UK
Company Reg No. 5365166. VAT No. 791350132