Make fantastic serving dishes with this rectangular mould. Wonderful for centrepieces.
Measures 24cm x 13cm and is roughly 2cm deep. The flat area inside the dish measures 15cm x 5cm.
Bullseye Code: 8945
You may also like the Concave Dish Mould 8333.
Firing Schedule:
Please Read: This firing recommendation has been calculated using Bullseye Glass with a thickness of 6 mm in a Paragon GL24 kiln, and is courtesy of Bullseye Glass Co.
Segment
Rate (C/hr)
Temp.
Hold
1
167C
677C
1:15
2
999
482C
1:00
3
56C
371C
:00
Troubleshooting
Small kilns may require the process temperature reducing. In the Hobbyfuser and HotStart Pro, reduce the top temperature from 677C to 654C. In the Firebox 14, reduce the top temperature from 677C to 634C. All kilns vary, as does glass viscosity. Testing is necessary.
Remove the shelf when slumping in small kilns.
Side firing kilns may require more time in the first ramp than top firing kilns.
Bubbles in slumping are caused by firing too high or holding too long at process temperature.
Cracked moulds or cracked glass is caused by firing too fast in the first ramp or cooling too fast.
Devitrification on the outside of a slumped piece is caused by firing too high or holding too long at process temperature.
Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. Mould manufacturers allow a tolerance of up to 2cm. We strongly recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.
All our moulds are designed for multiple use and with care should last for many firings.