Please Log In

Forgot your password?

Hop on board...

Are you a new Customer? Click here to register.

Loading Zoom, please wait

Deep Bowl with Flat Base Mould 8294 (17cm diameter)

Price £17.86 Inc VAT (£14.88 ex VAT)

 Go Back to Circular Moulds 

All prices include VAT.

Stock Status: More than 10 in stock
We Also Recommend for Deep Bowl with Flat Base Mould 8294 (17cm diameter):
Product Information
Mould 8294 - Deep bowl with flat base. 

Great as an individual salad bowl! This is a spherical mould with a flat base, so you get a clean curve without compromising on the stability of your bowl.

Inner Dimensions: Diameter: 17 cm, Height: 4.1 cm 
Outer Dimensions: Diameter: 18.7 cm, Height: 4.6 cm 
Base Dimensions: Diameter: 7 cm

Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. Mould manufacturers allow a tolerance of up to 2cm. We strongly recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.

Will this mould fit in my glass kiln?

Use with the 17cm clear pre-cut circles.

Firing Schedule:

Please Read: This firing recommendation has been calculated using Bullseye Glass with a thickness of 6 mm in a Paragon GL24 kiln. 

Segment Rate (C/hr) Temp. Hold
1 167C 668C 1:00
2 999 482C 1:00
3 56C 371C :00


  • Small kilns may require the process temperature reducing. In the Hobbyfuser and HotStart Pro, reduce the top temperature from 668C to 645C. In the Firebox 14, reduce the top temperature from 668C to 625C. All kilns vary, as does glass viscosity. Testing is necessary.

  • Remove the shelf when slumping in small kilns.

  • Side firing kilns may require more time in the first ramp than top firing kilns.

  • Bubbles in slumping are caused by firing too high or holding too long at process temperature.

  • Cracked moulds or cracked glass is caused by firing too fast in the first ramp or cooling too fast.

  • Devitrification on the outside of a slumped piece is caused by firing too high or holding too long at process temperature.

All our moulds are designed for multiple use and with care should last for many firings.


Product Reviews

There are currently no reviews for this product. Be the first to Write a review

Registered office: 5 Havyat Park, Wrington, Bristol, BS40 5PA, UK
Company Reg No. 5365166. VAT No. 791350132