Please Log In

Forgot your password?

Hop on board...

Are you a new Customer? Click here to register.

Loading Zoom, please wait

Spherical Bowl Mould 8136 (19.3cm diameter x 2.3cm)

Price £25.12 Inc VAT (£20.93 Ex VAT)

4.3 out of 5 stars (3 Customer Reviews)
 Go Back to Circular Moulds 

All prices include VAT.

Stock Status: More than 10 in stock
We Also Recommend for Spherical Bowl Mould 8136 (19.3cm diameter x 2.3cm):
Product Information
Spherical Bowl Mould  

Create beautifully rounded bowls (without a flat base) using this mould.

Want to make an appealing, perfectly rounded bowl without the fuss of cutting circles? Try slumping a pre-cut 20cm circle into this beautifully simple mould.

While as a decorative piece movement can be a positive attribute, for more stability you could add bumper stops or rubber pads to the base of your finished bowl, or secure with Museum Gel.

Inner Dimensions: Diameter: 19.3 cm, Height: 2.3 cm 
Outer Dimensions: Diameter: 19.9 cm, Height: 3 cm 
This mould fits in the HotStart Pro kiln.

Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. We strongly recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.

Will this mould fit in my glass kiln?

We stock a range of 20cm transparent and opalescent pre-cut circles measured to fit this mould.


Firing Schedule:

Please Read: This firing recommendation has been calculated using Bullseye Glass with a thickness of 6 mm in a Paragon GL24 kiln, and is courtesy of Bullseye Glass Co. 

Segment Rate (C/hr) Temp. Hold
1 167C 657C :05
2 999 482C 1:00
3 56C 371C :00
4 999 21C :00


  • Small kilns may require the process temperature reducing. In the Hobbyfuser and HotStart Pro, reduce the top temperature from 657C to 634C. In the Firebox 14, reduce the top temperature from 657C to 614C. All kilns vary, as does glass viscosity. Testing is necessary.

  • Remove the shelf when slumping in small kilns.

  • Side firing kilns may require more time in the first ramp than top firing kilns.

  • Bubbles in slumping are caused by firing too high or holding too long at process temperature.

  • Cracked moulds or cracked glass is caused by firing too fast in the first ramp or cooling too fast.

  • Devitrification on the outside of a slumped piece is caused by firing too high or holding too long at process temperature.

All our moulds are designed for multiple use and with care should last for many firings.

Product Reviews
4.3 out of 5 stars
3 out of 5 stars Wednesday 01 April, 2015 By Carol Edwards
Makes a nice bowl but does not have a flat bottom so spins on the table. Rather disappointing.
5 out of 5 stars Friday 28 October, 2011 By Richard Greenwell
This is a lovely mould it makes great bowls with a really nice shape i would deffinatly recomend it.
5 out of 5 stars Thursday 12 May, 2011 By Ruth Richards-Hill
I'm a very satisfied customer. Just the right depth, for its purpose, light for the arthritic glass maker yet robust and high quality slip cast mould - highly recommended. Buy it!

Write a review