Mould 8125 Small Lamp Bender 27 x 23cm x 10cm
Mould 8032 Drop Out Ring 23cm x 13cm (od x id)

Medium Drop Out Ring Mould 8032 (23cm outer x 13cm inner dia.)

Medium Lamp Bender Mould 8126 (35 x 37cm x 11cm)

Medium Lamp Bender Mould 8126 (35 x 37cm x 11cm)

Small Lamp Bender Mould 8125 (27cm x 23cm x 10cm)

£54.05 £45.04
More than 10 in stock
SKU
Z-G013
Small lamp bender mould.  

Create lamps or other art pieces with this semi-cylindrical mould.  Try glueing two identically slumped glass pieces together and adding a base to create a deep vessel or vase.

Size: 27cm x 23cm, depth 10cm.  

Bullseye Code: 8725

Width of glass needed to drape fully round the mould: 30cm

Fits in the HotStart Pro kiln (witout kiln shelf) or bigger. If your kiln is smaller, try the Mini Lamp Bender 8354.

Will this mould fit in my glass kiln?

Firing Schedule:

Please Read: This firing recommendation has been calculated using Bullseye Glass with a thickness of 6 mm in a Paragon GL24 kiln, and is courtesy of Bullseye Glass Co. 

Segment Rate (C/hr) Temp. Hold
1 167C 649C :20
2 999 482C 1:00
3 56C 371C :00

Troubleshooting

  • Small kilns may require the process temperature reducing. In the Hobbyfuser reduce the top temperature from 649C to 626C. In the Firebox 14, reduce the top temperature from 649C to 606C. All kilns vary, as does glass viscosity. Testing is necessary.

  • Remove the shelf when slumping in small kilns.

  • Side firing kilns may require more time in the first ramp than top firing kilns.

  • Bubbles in slumping are caused by firing too high or holding too long at process temperature.

  • Cracked moulds or cracked glass is caused by firing too fast in the first ramp or cooling too fast.

  • Devitrification on the outside of a slumped piece is caused by firing too high or holding too long at process temperature.

Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. Mould manufacturers allow a tolerance of up to 2cm. We strongly recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.

All our moulds are designed for multiple use and with care should last for many firings.

Write Your Own Review
You're reviewing:Small Lamp Bender Mould 8125 (27cm x 23cm x 10cm)
Your Rating
Customer Questions
No Questions
Did you find what you were looking for?