Please Log In



Forgot your password?

Hop on board...

Are you a new Customer? Click here to register.

Register
Loading Zoom, please wait

Single Candle Bridge Mould 8303 (17.5cm x 12.3cm x 3.8cm)

Price £25.07 Inc VAT (£20.89 Ex VAT)

5 out of 5 stars (1 Customer Review)
 Go Back to Miscellaneous Moulds 

All prices include VAT.

Stock Status: 10 Units in Stock
Ref:
Z-G022
We Also Recommend for Single Candle Bridge Mould 8303 (17.5cm x 12.3cm x 3.8cm):
Product Information
Candle Bridge Mould  

Create chic, stylish candle holders with this convex slumping mould.

Inner Dimensions: Length: 17.5 cm, Width: 12.3 cm, 
Outer Dimensions: Length: 13 cm, Width: 18.2 cm, Height: 5 cm 
Opening Dimensions: Diameter: 8 cm, Height: 1.5 cm

Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. We strongly recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.

Will this mould fit in my kiln?

 

For a circular candle opening, try the Elegant Candle Holder mould. 

Firing Schedule:

Please Read: This firing recommendation has been calculated using Bullseye Glass with a thickness of 6 mm in a Paragon GL24 kiln, and is courtesy of Bullseye Glass Co. 

Segment Rate (C/hr) Temp. Hold
1 167C 682C 1:30
2 999 482C 1:00
3 56C 371C :00
4 999 21C :00

Troubleshooting

  • Small kilns may require the process temperature reducing. All kilns vary, as does glass viscosity. Testing is necessary.

  • Remove the shelf when slumping in small kilns.

  • Side firing kilns may require more time in the first ramp than top firing kilns.

  • Bubbles in slumping are caused by firing too high or holding too long at process temperature.

  • Cracked moulds or cracked glass is caused by firing too fast in the first ramp or cooling too fast.

  • Devitrification on the outside of a slumped piece is caused by firing too high or holding too long at process temperature.

  • To prevent the glass pulling in at the edges when it slumps into the top of the mould, make sure your glass is slightly wider (no more than 5mm) than the edge of the mould. This will stop the glass pulling in at the sides.

All our moulds are designed for multiple use and with care should last for many firings.


Product Reviews
5 out of 5 stars
5 out of 5 stars Friday 28 February, 2014 By Marie Maher - See all my reviews
This candle holder is really useful mould
Ive made them in blue stripes which looks very modern with clean lines. Ive also dont them in retro acid yellow and black and they look very 1960s
Love the shape so Ive ordered another!

Write a review