Mould 8299 Square plate simple curve (16 x 16 x 2cm)
Mould 8298 Square slumper flat base (8 x 8 x 1.5cm)

Square Slumper with Flat Base Mould 8298 (8.3cm x 8cm x 1cm)

Mould 8033 Drop out ring small (18od x 8id)

Small Drop Out Ring Mould 8033 (18cm outer dia.x7.7cm inner dia)

Square Plate Simple Curve Mould 8299 (15.4cm x 15.2cm x 1.7cm)

Rating:
90% of 100
£21.00 £17.50
More than 10 in stock
SKU
P011
Square Plate Mould 8299

Create an elegant and practical dish with this mould. Produces a square plate with a simple, pleasing curve.

Inner Dimensions: Length: 15.4 cm, Width: 15.2 cm, Height: 1.7 cm 
Outer Dimensions: Length: 15.8 cm, Width: 15.9 cm, Height: 2.4 cm 
Base Dimensions: Length: 8.7 cm, Width: 8.5 cm

Bullseye Code: 8899

Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. Mould manufacturers allow a tolerance of up to 2cm. We strongly recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.

Will this mould fit in my kiln?

You might also like the Square Platter mould 8038.

 

Firing Schedule:

Please Read: This firing recommendation has been calculated using Bullseye Glass with a thickness of 6 mm in a Paragon GL24 kiln, and is courtesy of Bullseye Glass Co. 

Segment Rate (C/hr) Temp. Hold
1 167C 663C 1:30
2 999 482C 1:00
3 56C 371C :00

Troubleshooting

  • Small kilns may require the process temperature reducing. In the Hobbyfuser and HotStart Pro, reduce the top temperature from 663C to 650C. In the Firebox 14, reduce the top temperature from 663C to 640C. All kilns vary, as does glass viscosity. Testing is necessary.

  • Remove the shelf when slumping in small kilns.

  • Side firing kilns may require more time in the first ramp than top firing kilns.

  • Bubbles in slumping are caused by firing too high or holding too long at process temperature.

  • Cracked moulds or cracked glass is caused by firing too fast in the first ramp or cooling too fast.

  • Devitrification on the outside of a slumped piece is caused by firing too high or holding too long at process temperature.

All our moulds are designed for multiple use and with care should last for many firings.

Write Your Own Review
You're reviewing:Square Plate Simple Curve Mould 8299 (15.4cm x 15.2cm x 1.7cm)
Your Rating
Customer Questions
No Questions
Did you find what you were looking for?
We found other products you might like!