This little mould makes for a perfect side salad dish.
Diameter 13.5cm, depth 3.3cm. Even radius throughout the mould, no base.
Perfect for using with the 13.5cm clear pre-cut circle.
Firing Schedule:
Please Read: This firing recommendation has been calculated for use with Bullseye Glass of average viscosity with an even thickness of 4 - 6 mm. The chart shown below is also based on the assumption that you are using a top fired kiln, e.g. Nabertherm GF75, GF240 etc.
Troubleshooting
· Small kilns such as Skutt Firebox may require hold time at process temperature reducing.
· Side firing kilns will require more time in the first ramp than top firing kilns.
· Bubbles in slumping are caused by firing too high or holding too long at process temperature.
· Remove the shelf when slumping in small kilns.
· Cracked moulds or cracked glass is caused by firing too fast in the first ramp or cooling too fast.
· Devitrification on the outside of a slumped piece is caused by firing too high or holding too long at process temperature.
Latest Twitter Posts