Double curve mould.

Create beautiful curvaceous art pieces by slumping your work in this double curve mould.

Size: 34cmx41cm Depth 5cm.

Bullseye Code: 8643

Length of glass to fit mould fully: Approximately 44cm

Please note does not fit in the Fusion 16, Hotstart, Firebox, Hobbyfuser or SC2. Only fits in larger kilns. For a smaller double curve mould, try mould 8350.

Will this mould fit in my glass kiln?

Firing Schedule:

Please Read: This firing recommendation has been calculated using Bullseye Glass with a thickness of 6 mm in a Paragon GL24 kiln, and is courtesy of Bullseye Glass Co.

Segment	Rate (C/hr)	Temp.	Hold
1	167C	657C	:10
2	999	482C	1:00
3	56C	371C	:00

Troubleshooting

All kilns vary, as does glass viscosity. Testing is necessary.
Remove the shelf when slumping in small kilns.
Side firing kilns may require more time in the first ramp than top firing kilns.
Bubbles in slumping are caused by firing too high or holding too long at process temperature.
Cracked moulds or cracked glass is caused by firing too fast in the first ramp or cooling too fast.
Devitrification on the outside of a slumped piece is caused by firing too high or holding too long at process temperature.

Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. Mould manufacturers allow a tolerance of up to 2cm. We strongly recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.

All our moulds are designed for multiple use and with care should last for many firings.

?